Administration Commands

For all those commands you will need the "Administrator" permission.

How to setup a prefix

Command : &prefix (prefix)

How to manage modules (categories)

[WARNING] You can only load/unload the following modules : anime, kimetsu, logs, utility, moderation, actions.

Command : &modules

It allows you to see with functionnality are enabled or not.
If you unload a module, it disables the categorie and you can't use the commands from that categorie.

Command : &load (module)

It enables the module.

Command : &unload (module)

It disables the module.

How to configure channels

Command : &setchannel

When you click on one of the emoji you can configure a specific channel.

Channels :

  • Command's Channel : Where the commands can be executed except for the admin and moderation commands

  • Moderation/Adminstration Logs : Where the punishments/logs are sent

Log example
  • Welcome Channel : Where the welcome messages are sent.

  • Goodbye Channel : Where the goodbye messages are sent.

How to reset a specific configuration

Command : &reset

You can choose with configuration you want to reset.
Example with the prefix.

How to set the verification message

Command : &verif

Different options to setup the verification.

1st Step : Setup the verification role

After reacting on the message, mention the role.

2nd Step : Setup the verification message

Result :

How to configure Reaction Roles

Command : &reactrole

Different options of the Reactions Roles' Command.
Configuration's Menu.

1st Step : Adding roles

2nd Step : Adding the Reaction Roles Message

You set up to 20 reactions roles !

How to set the Muted Role

Command : &setrole

How to configure a Welcome Message

Command : &welcome

1st Step : Configuring the Welcome

2nd Step : Set the Welcome Message

3rd Step : Set the Welcome Message Image (with image/gif link)

To check if your image/gif is working use the welcome command to see your message.

Welcome Example :

How to configure a Goodbye Message

Command : &goodbye

1st Step : Configuring the Goodbye

2nd Step : Set the Goodbye Message

3rd Step : Set the Goodbye Message Image (with image/gif link)

To check if your image/gif is working use the goodbye command to see your message.

Goodbye Example :

Last updated

Was this helpful?